A Simple, self-explanatory Guide to Help with The Installation of Car Decal
You are practically limited to your imagination when it comes to personalizing your car. How about you use a custom decal to spruce up your car and explore the many beautiful options at your disposal in the car decal world? Of course, adding some custom decal takes a bit more prep work, but the results are something you will be very proud of. Here is a step by step guide to help you add your own decals and you can always check it out here to have a look at the wide variety of car decals available.
How about you start by deciding where exactly you would want to have your decal placed on your car? How about you find a flat spot on your car but ensure the texture can hold the dcor perfectly. Your dashboard, window or body panel will do just ensure the custom decal you choose can withstand the specific elements of the spot. Step two simply entails dry fitting the decal to ensure it looks and is positioned exactly how you want it to be. Dry fitting is simply placing the decal atop its location without peeling off the backing paper.
As you dry fit, you might want to pay enough attention to the exact spot of the decal, so you have it centered and straight. This is where you need a small level or a measuring tape so you can measure its exact position nearest to the edges to ensure it is straight. Last but not least, put some masking tape on the corners of where the decal lies to know the accurate spot to place it.
With your layout clearly defined, the next step is to prep the area to ensure the decal stays put for the longest possible time. You will need a fast drying cleaning solution such as rubbing alcohol and a clean, lint-free towel. You can then peel off the backing on the decal which you can do in two ways. This you can do by peeling off the entire backing paper all at once or doing it gradually as you lay on the clean surface. As you lay it over the surface, it is important to apply some pressure to the custom decal to avoid bunching it in the end. As you press down the decal applying firm pressure, you might want to ensure there are no bubbles so that the decal sets properly. Let it sit uninterrupted for 30 minutes, and you are done.